Dot Hill Systems SANnet II 200 Servisní příručka stáhnout pdf (Strana 71)

Chapter 4 Connecting Your Array 4-23

No SFPs are plugged into the drive channels. This configuration is appropriate for

connecting to up to four hosts or fibre switches, with no connection to expansion units

(see Figure 4-19 and Figure 4-20).

Figure 4-19 SANnet II 200 FC Array Default Single Controller SFP Placement

Figure 4-20 SANnet II 200 SATA Array Default Single-Controller SFP Placement

Note – The SANnet II 200 SATA SE array configuration does not include SFPs. SFPs

must be ordered separately.

In a default SANnet II 200 FC expansion unit, SFPs are initially plugged into the left-

most port of the upper I/O expansion module and right-most port of the lower I/O

expansion module (see Figure 4-21).

Note – The SANnet II 200 SATA SE array does not support this configuration.

Host port FC0

Host port FC1

Host port FC4

Host port FC5

Host port FC1

H/D/RCC

Host port FC0

Host port FC4

Host port FC5

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 209 210

Žádné komentáře

Dot Hill Systems SANnet II 200 Servisní příručka Strana 71